Skip to main content
Edexcel IGCSEGeneralGeneral Applications9 Marks

A student sets up a circuit as shown in [Figure 2]. The circuit contains a power supply, a resistor, and a light-dependent resistor (LDR).

  1. (a)State the purpose of the LDR in this circuit.[1]
  2. (b)Describe how the resistance of the LDR changes when the light intensity incident on it increases.[2]
  3. (c)The power supply has a voltage of 6.0 V. The current through the resistor is 0.50 A. Calculate the resistance of the resistor.[3]
  4. (d)Explain how the brightness of the lamp in the circuit would change if a voltmeter was connected in series with the LDR.[3]

This question uses a diagram from the original paper, which isn't shown here. Open the full paper from the past papers archive to see it.

Mark scheme

Marking points from the official mark scheme. The mark or mark type is shown in brackets.

  1. 3(a) B1 for to detect / measure / respond to light (intensity) / detect changes in light (intensity)
  2. 3(b) B1 for resistance decreases
  3. 3(b) B1 for as light intensity increases (or inverse for decreasing light)
  4. 3(c) M1 for (R = V / I) OR (6.0 / 0.50)
  5. 3(c) A1 for 12
  6. 3(c) A1 for (ohms / Ω) (units required for full marks)
  7. 3(d) M1 for (voltmeter has) very high / infinite resistance
  8. 3(d) M1 for (voltmeter in series would) block / stop the current / current would be very small
  9. 3(d) A1 for lamp would go out / become very dim / not light up (any equivalent)

Write your answer and get it marked

On Oracle Prep you can write or photograph your own answer and have it marked by AI against this mark scheme, with feedback on what you missed.

Sign up free →

About this question

Topic
General Applications, Edexcel IGCSE General. Structured question, 9 marks.

Questions and mark schemes are from past examination papers and remain the copyright of the exam board. How Oracle Prep builds its content

Related General questions

© 2026 Oracle Prep